Shunyata SIGMA-v2 CLOCK-75 - 1 meter

2'329.00 CHF pièce de 1 mètre
2'448.00 Sie sparen 119.00
Shunyata SIGMA V2 CLOCK 75 Series cables showcase technological innovation and design execution that simply does not exist elsewhere — at any price. Sigma Series cables combine meaningful parts innovations with objective measurement and an artisan’s eye for construction quality. Unlike many cost-no-object cable products that have little in the way of discernible science, Sigma Series products incorporate an array of definable technologies that sets the standard for quality and performance in the cable industry.
PMZ
Shunyata Research digital cables are produced using a ‌Precision Matched Impedance cable geometry. This means that tolerances of the conductor surface, dielectric extrusion, and the precision of the braided shield are held to minute variances. To achieve these tight tolerances, the extrusion and braiding machines must be run at one-quarter speed during the manufacturing process. The result is better performance through a reduction of cable-induced signal jitter.

ArNi®
wire was designed by Shunyata Research to be the finest quality wire available. It begins with the highest purity of copper and silver metals available, including Ohno (single crystal), PCOCC silver and OFE C0101 conductors. Fluorocarbon dielectrics, usually only found in aerospace applications that have exceptional electrical characteristics including extremely low dielectric absorption, high dielectric strength and superb heat resistance.  When used in digital wiring it significantly reduces transient energy storage and release which affects phase noise performance.

CMODE
Common-node noise is different than differential noise and is much more difficult to measure and eliminate. For the purest signal possible, Shunyata Research has developed a CMODE filter that effectively reduces common-mode noise without introducing the sonic compression effects associated with conventional filters. It reduces high-frequency noise distortion while delivering an analog ease and palpable background silence that closes the gap between digital and analog systems.

PMZ Connectors
Pulse timing is critical to digital transmission accuracy.  It is critical that a digital connector’s impedance precisely match the cables's characteristic impedance.  A mismatched connector will create signal reflections which increases digital jitter or phase noise. A 50-ohm cable requires a 50-ohm termination — not the commonly used 75-ohm connector. Shunyata Research is careful to ensure that every cable and connector are precisely matched for a seamless component to component connection.

Kinetic Phase Inversion Processing
Kinetic Phase Inversion Processing was developed by Caelin Gabriel after years of research into the underlying causes of various effects such as burn-in, wire directionality and the effects of cryogenic treatment. He discovered that there was an underlying core principle that burn-in and cryogenics only partially addressed. Once the governing principle was understood it became possible to create a processor that reduces the need for long burn-in periods and eliminates the effects of cryogenic treatment. Four-days of continuous KPIP™ processing dramatically reduces the sonic ups and downs associated with burn-in, delivering a relaxed and natural presentation.

APPLICATIONS
For all video system that require CLOCK connectors of extraordinary quality.

It takes us fifteen days to get your cables to the length you need from Shunyata. Click on "Request Information" above to get an offer. It takes CHF 68.- by 0.25 meter extra and per pair to get the length you need.
Cable Type: PMZ coaxial
Conductors: ArNi ® / Silver
Dielectric: Fluorocarbon
Impedance: 75 ohms
Connectors: BNC-75
CMODE Modules: 2
KPIP Processing: 4-days
Length: 1.00 meters
Safety Assurance: Continuity and polarity tests – by two technicians
HiPOT tests insulation breakdown @ 1,200 VAC
24/7 Kostenlos unsere Berater anrufen
0 800 800 660
24/7 Kostenlos unsere Berater anrufen 0 800 800 660